The disruption construct was developed by amplifying an 800 bp 5′ flanking region to Gba1 using the primers GbetaKOF1 and www.selleckchem.com/products/hsp990-nvp-hsp990.html F2 and cloning this into the KpnI and XhoI sites in pBSK-phleo [11]. Similarly, the 823 bp 3′ flank of Gba1 was amplified with GbetaKOR1 and R2 and cloned into Pst1 and BamHI sites subsequent to the 5′ flank cloning. The subsequent

construct, pBphleo-GβKO, was transformed into S. nodorum SN15 as described below. Preparation and transformation of S. nodorum protoplasts Protoplasts were prepared from S. nodorum mycelia as described by Solomon et al.[11]. Transformation was performed as per Solomon et al. [22]. Fungal transformants were screened for homologous recombination by PCR. PCR primers were designed to anneal Selleckchem Thiazovivin to the non-coding genomic regions flanking either Gba1 or Gga1 in S. nodorum SN15. The screening primers are listed in Table 1. RT-(q)PCR determination of gene copy number The number of targeted gene insertions following fungal transformation was determined by quantitative real-time PCR (RT-qPCR) as described by [23]. Briefly, this involved calculating the ratio of the RT-qPCR determined cycle-threshold (CT) of the inserted phleomycin cassette to that of an endogenous single-copy actin gene; comparative to a known single-copy phleomycin cassette-possessing strain

of S. nodorum. CT Values were determined from reactions consisting of four gDNA amounts (100 ng, 33.5 ng, 10 ng and 3.35 ng) for each template, performed in triplicate. The primer pairs PhleoqPCRf and PhleoqPCRr or ActinqPCRf and ActinqPCRr were each used at 1.2 μM with 1× QuantiTect SYBR Green PCR Master Mix (DNA Taq Polymerase, QuantiTect SYBR Green PCR Buffer, dNTPs, SYBR Green I dye; 6-phosphogluconolactonase Qiagen, Australia), in a reaction volume of 15 μl. Thermal cycling consisted of 95°C for 15 minutes, followed by 40 cycles of (94°C for 15 seconds, 57°C for 30 buy 4EGI-1 seconds and 72°C for 30 seconds). Histological staining and microscopy Cross-sections of fungal tissues were examined by compound microscopy as described

by [12]. An excised region of the culture was fixed overnight in FAA [3.7% (v/v) formaldehyde, 5% (v/v) glacial acetic acid, 47% (v/v) ethanol] and dehydrated in 3 hour stages of ascending concentrations of ethanol, at 70%, 90% and 100%. Cultures were then rinsed in chloroform and infiltrated with molten Paraplast® paraffin wax and the fungal culture cross-sectioned in 10 μm sections with a Shandon MX35 blade using a Leica Microtome RM225 (Leica Microsystems). Series of sections were embedded to a glass slide by overnight incubation at 60°C. Wax was removed from the sectioned tissue by two 5-minute rinses with xylene. Sections were stained with 1% toluidine blue. Light microscopy was performed using an Olympus BH-2 compound microscope equipped with Olympus DP12 image acquisition software (Olympus America Inc., USA).