ZT is defined as S 2
σT/κ, and the power factor is S 2 σ, where S is the Seebeck coefficient, σ is the electrical conductivity, κ is the thermal conductivity, and T is the absolute temperature. High-performance thermoelectric materials with high ZT values should have a large Seebeck coefficient, high electrical conductivity, and low thermal conductivity. Over the past few decades, bismuth (Bi) and its alloys have been regarded as the most interesting TE material applications at room temperature [4–6] because Bi is semi-metallic with unique electronic properties such as an extremely small carrier effective mass, low carrier density, high carrier mobility, Blasticidin S price long carrier mean free path, and a highly anisotropic Fermi surface [7]. However, high-performance TE devices with high ZT values have not yet been realized experimentally by employing Bi materials. Recently, for the application in high-performance TE devices, various one-dimensional (1D) nanostructured TE materials, such as nanowires and check details nanotubes, have been studied widely with the aim of
reducing the phonon mean free MK 2206 path [8–12]. Despite the low thermal conductivity of 1D nanostructured TE materials compared with their bulk counterparts, 1D nanostructured materials are not considered suitable for TE devices because their thermal properties depend greatly on the dimensionality and morphology [8–10]. More recently, to overcome these problems inherent of 1D nanostructured TE device systems, several researchers have alternatively studied
two-dimensional (2D) thin films [13, 14]. In 2010, Tang and co-workers reported that the thermal conductivity of holey Si thin films is consistently reduced by around two orders of magnitude upon the reduction of the pitch of the hexagonal holey pattern down to 55 nm Carnitine dehydrogenase with approximately 35% porosity [13]. Similarly, Yu and co-workers revealed that a Si nanomesh structure exhibits a substantially lower thermal conductivity than an equivalently prepared array of Si nanowires [14]. Accordingly, we believe that 2D nanoporous materials should be promising scalable TE nanostructured materials. In this report, we present the fabrication of nanoporous 2D Bi thin films, in which high-density ordered nanoscopic pores are prepared by the nanosphere lithography (NSL) technique that we developed previously [15]. The preparation of large-scale nanoporous 2D Bi thin films is based on e-beam evaporation of Bi metal masked by a monolayer of polystyrene (PS) beads (200 to 750 nm in diameter), followed by a reactive ion-etching (RIE) treatment. We successfully demonstrate the thermal conductivity of nanoporous 2D Bi thin films via the four-point-probe 3ω method at room temperature [16, 17]. The extracted thermal conductivities of the nanoporous Bi thin films are greatly suppressed, relative to those of bulk materials because of the strongly enhanced boundary scattering via charge carriers and bipolar diffusion at the pore surfaces [18].